KEP BATCHtrol II - Page 24

20
3-10 Setup Procedure For The Batcher
3-10 Setup Procedure For The Batcher
(continued)
From the previous page, we are in the
CODE
setting portion of the Lockout setup Menu.
PRESS
DISPLAY
CODE
Store new security time.
Enters device routine to program in a 4 digit Lockout Code. The word CODE appears
briefl y then the current Lockout Code number is displayed.
0 Flashes.
Clears out existing Lockout Code.
1234 Flashes.
Sample Lockout Code, or enter desired value from notes or worksheet.
Be sure to record any changes in the lockout code in case it is forgotten!
Be sure to record any changes in the lockout code in case it is forgotten!
Last count, unit now in Run Mode.
Store new LOCKOUT Code. (Sample tryout below.)
LOCK ON
Enter the sample / new value . . . the unit is now locked!
LOCK OFF
Enter the sample / new value. . . the unit is now unlocked!
The lockout procedure is fi nished.
ENT
CLR
1 2 3 4
ENT
1 2 3 4
1 2 3 4
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com