770/GS/GJ-BA-defsi-0023 121
Control Commands with upper-case Letters or Special Characters
ESC P CR LF
PRINT (print, activate/block auto print)
ESC S CR LF
Restart/self-test
ESC T CR LF
Tare
ESC Z CR LF
Internal adjusting*
The P, T, and Z commands do not affect the menu code settings of the balance. The S
command causes the processor to reinitialise (turns the balance off and back on again).
The balances will operate according to the commands available up until the processor is
reinitialised. Once the balance has been turned on, the processor will always recognise
the codes entered by the user in the balance operating menu.
ESC O CR LF
Block the keys
ESC R CR LF
Release the keys
Important Note !
The
PRINT
key is not blocked !
Adaptation to Ambient Conditions
ESC K CR LF
Very stable
ESC L CR LF
Stable
ESC M CR LF
Unstable
ESC N CR LF
Very unstable
* = only for balances with a built-in automatic adjusting function
To Next Page
Loading...
Need help?
General
