To Next Page

To Previous Page

572/573/KB/DS/FKB-BA-defsi-0651

7 Operation_________________________________________________________________ 35

7.1 Display control panel _________________________________________________________ 35

7.2 Operation___________________________________________________________________ 36

7.2.1 Weighing with Tare ________________________________________________________________ 36

7.2.2 Count – Selection Preference Piece ____________________________________________________ 36

7.2.3 Percent % ________________________________________________________________________ 36

7.2.4 Formula Weighing _________________________________________________________________ 36

7.2.5 Tolerance Weighing ________________________________________________________________ 36

7.2.6 Adjust ___________________________________________________________________________ 38

7.2.7 Preselect Tare _____________________________________________________________________ 38

7.2.8 Auto Tare ________________________________________________________________________ 38

7.2.9 Speed ___________________________________________________________________________ 38

7.2.10 Auto Off_______________________________________________________________________ 38

7.2.11 Variable Factor__________________________________________________________________ 38

7.2.12 Preselect Unit___________________________________________________________________ 38

7.3 Interface RS 232 C ___________________________________________________________ 40

7.4 RS 232 C Data output via interface RS 232 C _____________________________________ 40

7.4.1 There are 4 methods for the data output via RS 232 C______________________________________ 40

7.4.2 Description of the data transfer________________________________________________________ 41

7.4.3 Numerator________________________________________________________________________ 41

7.5 Printer _____________________________________________________________________ 41

7.6 Underfloor weighing __________________________________________________________ 41

8 Maintenance, upkeep, disposal________________________________________________ 42

8.1 Cleaning ____________________________________________________________________ 42

8.2 Maintenance, upkeep _________________________________________________________ 42

8.3 Disposal ____________________________________________________________________ 42

9 Troubleshooting ___________________________________________________________ 42

10 Declaration of conformity__________________________________________________ 43

KERN KB Series User Manual

Questions and Answers: