EN
63
WARNING:
Electrical Shock Hazard
Disconnect electrical power before installing dishwasher. Failure to do so could result
in death or electrical shock.
ATTENTION:
The installation of the pipes and electrical equipments should be done by professionals.
5.1. About Power Connection
WARNING:
For personal safety:
• Do not use an extension cord or an adapter plug with this appliance.
• Do not, under any circumstances, cut or remove the earthing connection from
the power cord.
Electrical requirements
Please look at the rating label to know the rating voltage and connect the dishwasher
to the appropriate power supply. Use the required fuse 10A/13A/16A, time delay fuse
or circuit breaker recommended and provide separate circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being corresponds to those on the rating
plate. Only insert the plug into an electrical socket which is earthed properly. If the
electrical socket to which the appliance must be connected is not appropriate for the
plug, replace the socket, rather than using a adaptors or the like as they could cause
overheating and burns.
NOTE:
Ensure that proper earthing exists before use.
5.2. Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that
it is fastened tightly in place. If the water pipes are new or have not been used f xtended
period of time, let the water run to make sure that the water is clear. This precaution is
needed to avoid the risk of the water inlet to be blocked and damage the appliance.
CHAPTER 5: INSTALLATION INSTRUCTION
To Next Page
Loading...
Need help?
General
