EN
66
NOTE:
Only apply to the free standing dishwasher.
5.5. Free Standing Installation
Fitting between existing carbinets
he height of the dishwasher, 845 mm, has been designed
in order to allow the machine to be fitted between existing
cabinets of the same height in modern fitted kitchens. The
feet can be adjusted so that correct height is reached. The
laminated top of the machine does not require any particular
care since it is heatproof, scratchproof and stainproof.
Underneath existing work top
(When fitting beneath a work top) In most modern fitted
kitchens there is only one single work top under which
cabinets and electrical appliances are fitted. In this case
remove the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (a).
ATTENTION:
After removing the work top, the screws must be screwed again under the rear edge
of the top (b).
The height will then be reduced to 815 mm, as scheduled by the International Regulations
(ISO) and the dishwasher will fit perfectly under the kitchen working top
a
a
b
b
To Next Page
Loading...
Need help?
General
