EN
64
About the safety supply hose
The safety supply hose consists of the double walls. The hose’s system guarantees
its intervention by blocking the flow of water in case of the supply hose breaking and
when the air space between the supply hose itself and the outer corrugated hose is full
of water.
WARNING:
A hose that attaches to a sink spray can burst if it is installed on the same water line
as the dishwasher. If your sink has one, it is recommended that the hose be disconnected
and the hole plugged.
How to connect the safety supply hose:
• Pull The safety supply hoses completely out from storage compartment located
at rear of dishwasher.
• Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
• Turn water fully on before starting the dishwasher.
How to disconnect the safety supply hose:
• Turn off the water.
• Unscrew the safety supply hose from the faucet.
5.3. Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run
into the sink, making sure to avoid bending or crimping it. The height of drain pipe must
be less than 1000mm. The free end of the hose must not be immersed in water to avoid
the back flow of it.
NOTE:
Please securely fix the drain hose in either position A or position B.
safety supply hose
ordinary supply hose
To Next Page
Loading...
Need help?
General
