Kernau KFWM 8543 I - Automatic Fault Warnings; Error Codes E01 & E02; Error Codes E03 & E04

EN
104
(*) See the chapter regarding maintenance and cleaning of your machine.
CHAPTER 10. AUTOMATIC FAULT WARNINGS AND WHAT
TO DO
YourWashingMachineisequippedwithabuilt-infaultdetectionsystem,indicatedby
acombinationofflashingwashoperationlights.Themostcommonfailurecodesare
shownbelow.
TROUBLE
CODE
POSSIBLE FAULT WHAT TO DO
E01
Thedoorofyourmachine
isnotshutproperly.
Shutthedoorproperlyuntilyouhear
aclick.Ifyourmachinepersiststo
indicatefault,turnoffyourmachine,
unplugitandcontactthenearest
authorisedserviceagentimmediately.
E02
Thewaterpressureorthe
waterlevelinsidethemachine
maybelow.
Checkthetapisfullyturnedon.
Mainswatermaybecut-off.Ifthe
problemstillcontinues,yourmachine
willstopafterawhileautomatically.
Unplugthemachine,turnoffyour
tapandcontactthenearestauthorised
serviceagent.
E03
Thepumpisfaultyorpump
filteriscloggedorelectrical
connectionofthepump
isfaulty.
Cleanthepumpfilter.Ifthe
problempersists,contactthenearest
authorisedserviceagent.(*)
E04
Yourmachinehasexcessive
amountofwater.
Yourmachinewilldischargewater
byitself.Oncethewaterhasdrained,
turnoffyourmachineandunplug
it.Turnoffthetapandcontactthe
nearestauthorisedserviceagent.