Kernau KFWM 8543 I - Water Discharge Connection

EN
72
• Onceyouhavemadealloftheconnections,carefullyturnthe
watersupplyonandcheckforleaks.
• Ensurethatthenewwaterinlethosesarenottrapped,kinked,
twisted,foldedorcrushed.
• Ifyourmachinehasahotwaterinletconnection,thetemperature
ofthehotwatersupplyshouldnotbehigherthan70°C.
NOTE:
YourWashingMachinemustonlybeconnectedtoyourwatersupply
usingthesuppliednewfillhose.Oldhosesmustnotbereused.
3/4”
10 mm
WATER DISCHARGE CONNECTION
• Connectthewaterdrainhosetoastandpipeortotheoutletelbow
ofahouseholdsink,usingadditionalequipment.
• Neverattempttoextendthewaterdrainhose.
• Do not put the water drain hose from your machine into a
container,bucketorbathtub.
• Makesurethatthewaterdrainhoseisnotbent,buckled,crushed
orextended.
• Thewaterdrainhosemustbeinstalledatamaximumheightof
100cmfromtheground.
~ 95 cm ~ 140 cm
~ 145 cm ~ 95 cm
0 – max. 100 cm
~ 95 cm
~ 150 cm