49
✓ Due to the different intensity, the upper limits of "time" and "dose"
can be set are different. The "time" is not more than 120 seconds,
and the "dose" is not more than 5000 mJ/cm
2
.
➢ Press the “Ready” button and prepare to start the UV light output.
Press the “ON” button on the treatment handle, and the indicator
light on the handle will light up, “TREATMENT TIME” or “TREATMENT
DOSE” starts counting down. When the treatment is completed, press
the “ON” button again, the equipment will emit the light again
according to the previous setting.
Note: After pressing the light source “ON” button on the handle, the
screen will display “System in preparation...” as shown in Figure 4-9.
Please wait for 15 seconds. If the light source is still not turned on and the
screen displays “The device is not ready, please press the ‘Ready’
button again”, click the “Ready” button and then press the light source
“ON” button on the handle again.
To Next Page
Loading...
