Kernel KN-5000C - EMC Immunity Declaration; Electromagnetic Immunity Guidance

90
/flicker emissions EN
61000-3-3
buildings used for domestic purposes.
Guidance and manufacturer’s declaration - electromagnetic
immunity - for all equipment and systems
Guidance and manufacturer’s declaration — electromagnetic immunity
308nm Excimer System is intended for use in the electromagnetic environment
specified below. The customer or the user of 308nm Excimer System should assure that
it is used in such an environment.
Immunity
test
EN 60601 test
level
Compliance level
Electromagnetic
environment-guidance
Electrostatic
discharge
(ESD)
EN
61000-4-2
± 8 kV contact
± 15kV air
± 8 kV contact
± 15kV air
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30 %.
Electrostatic
transient /
burst
EN
61000-4-4
±2kV for power
supply lines
±1kV for
input/output lines
± 2 kV for power
supply lines
± 1 kV for
input/output lines
Mains power quality should
be that of a typical
commercial or hospital
environment.
Surge
EN
±1 kV differential
mode
± 1 kV differential
mode
Mains power quality should
be that of a typical