Risk of death and injury due to moving parts!
If moving parts are handled improperly, there is a risk of death and injury, as well
as material damage to the machine and system.
• Do not reach into or handle moving parts when the machine is in operation.
• Never open the covers when the machine is in operation.
• Observe the follow-up time: before opening the covers, take care to ensure
that all parts have stopped moving.
• Wear close-fitting protective clothing with low tensile strength in the danger
zones.
Risk of injury due to sharp edges and corners!
Sharp edges and corners can cause skin abrasions and cuts.
• Be careful when working in the vicinity of sharp edges and corners.
• If in any doubt, wear protective gloves.
Risk of injury due to the improper handling of operating materials and
resources!
The improper handling of operating materials and resources can have serious
health consequences or can even cause fatal injuries.
• Read the applicable material safety data sheets and manufacturer
instructions for the operating materials and resources.
• Wear corresponding personal protective equipment (e.g. gloves, safety
shoes, protective suit, respirator, protective eyewear, etc.).
• In the event of accidental eye contact, rinse the eyes thoroughly with plenty
of water and consult a doctor.
• If any materials or resources come into contact with the skin, clean
thoroughly with plenty of water.
• Ensure that the surrounding environment is sufficiently ventilated.
• Handle any warm materials and resources carefully. Coming into contact
with them can cause burns and scalds.
• Clean any parts, assemblies and components to remove any adhering oil,
grease and other contaminants.
• Avoid skin contact with operating materials and resources.
• Do not inhale any vapours produced by operating materials and resources.
• Do not handle close to an open flame and do not smoke.
To Next Page
Loading...
