Mähraupe HyCut
Operation DE
2021-01-27 36 / 65
1 Recoil starter
If the 48-volt voltage is too low, the combustion engine can be started manually. To
do so, put the toggle switch in the middle position and start up the engine with the
recoil stater (1). Slowly pull out the recoil starter (1) until you feel resistance and
then pull it through with the longest possible stroke.
6.4 Moving off / turning on the mowing unit
Before moving off / turning on the mowing unit, the tracked mower must be turned
on (see Chapter 6.3 Turning on the tracked mower on Page 35).
You can find the part numbers in the following list in Chapter 6.2 Wireless remote
control on Page 31.
• You should choose a clear and flat area the first time that you use the
mower.
• Ensure that there is no-one in front of or behind the machine!
• Reduce the speed by turning down the potentiometer on the remote control
(set to “Slow”).
• To move forwards, slowly push the forwards / reverse drive lever (1) on the
remote control forwards. The further forwards the drive lever is moved, the
faster the machine will move. To reduce the speed or stop the machine, let
go of the drive lever or move it to its central position.
• To move backwards, slowly push the forwards / reverse drive lever (1) on
the remote control backwards. The further backwards the drive lever is
moved, the faster the machine will move. To reduce the speed or stop the
machine, let go of the drive lever or move it to its central position.
• To adjust the direction of travel to the left or right, move the right / left drive
lever (9) in the direction in which you want the mower to move. If only the
right / left drive lever (9) is moved without the forwards / reverse drive lever
(1), the tracked mower will turn on the spot.
• In order to select the direction of travel and the right speed, the drive lever
must be kept in the corresponding position!
• The mowing unit is turned on and off with the mowing unit button (5) on the
remote control. The combustion engine must be started up before the
mowing unit can be turned on.
• The mowing unit can only be turned on when it is in a clear and
predetermined operational area.
• The mowing unit cannot be turned on outside of this area!
• Never turn on the mowing unit if there are children or animals in the work
area.
• If you notice that the mowing unit does not reach the desired speed when it
is turned on, turn it off immediately. If the mowing unit is in use, the initial
torque may be too high. Always turn on the mowing unit when it is not
loaded. To do so, raise the mowing unit if necessary (largest cutting height).
• The tracked mower is equipped with a load management system. If the
mowing unit is subjected to a high load / stress, the speed of the tracked
mower is automatically reduced. If the load / stress on the mowing unit is
reduced, the speed of the tracked mower will increase to the previous value
again.
To Next Page
Loading...
