Kersten HyCut - Transportation of the machine

Mähraupe HyCut
Transport, packaging and storage DE
2021-01-27 26 / 65
4.4 Transportation of the machine
NOTICE
Material damage due to improper handling!
Handling the machine improperly can cause damage.
• The machine must not be allowed to tip over or rotate around the horizontal
axis.
• The vehicles, tools and lifting equipment used must be suitable for the
weight of the transport units.
• The driver must be authorised to drive the vehicle.
Protective equipment
• Protective workwear
• Protective gloves
• Safety shoes
The following points must be observed when the machine is being transported:
• The loading, unloading and transportation of the machine must be performed
with suitable transport vehicles and trailers approved for use on public roads.
• The transport vehicles must be suitable for the weight and dimensions of the
machine that is to be transported.
• The machine must be attached to the marked attachment points.
• Sufficiently dimensioned lifting equipment / lashings must be used.
• The lifting equipment / lashings must not have any visible damage.
• For the transport, only vehicles, tools and lifting equipment / lashings that
are functional, flawless and suitable for the load to be transported should be
used.
• Do not stack the individual transport units on top of each other!
DANGER
Risk of death or injury due to the machine being transported incorrectly!
If the machine is transported incorrectly, there is a risk of death and injury, as well
as a risk of material damage to the machine and system!
• When using crane systems and / or forklifts, the user / driver must be
authorised to drive the vehicle.
• For transport, the machine should only be secured to the transport lugs /
lashing points provided.
• The machine must not be allowed to tip over or rotate around its own axis
when being lifted. Monitor the centre of gravity!
• Note the towing capacity of the towing vehicle and the permissible total
weight of the trailer.
• The loading ramps must be secured against sliding / rolling away.
• The loading ramps must have a sufficient load-bearing capacity.