Kersten HyCut - Page 58

Mähraupe HyCut
Malfunctions / Troubleshooting DE
2021-01-27 58 / 65
Malfunction
Possible causes
Remedy
The petrol engine cuts out
Ignition cable loose
Plug the spark plug connector firmly
into the ignition cable
Clamp the ignition cable fastening
Connect the spark plug connector
firmly to the spark plug
Fuel line blocked or incorrect fuel
used
Change the fuel filter, clean the fuel
line or fill the tank with fresh fuel
Ventilation in the fuel tank lid closed
or blocked
Open the ventilation, clean and
change the fuel tank lid
Water or dirt in the fuel system
Drain all fuel and clean the system, fill
with clean fuel
Air filter dirty
Clean or replace the air filter
Faulty spark plug
Replace the spark plug
Petrol engine becomes too
hot
Not enough engine oil
Fill up the engine oil immediately
Air filter dirty
Clean or replace the air filter
Cool air system restricted
Clean fan grille, clean interior cooling
fins
Faulty spark plug
Replace the spark plug
Petrol engine often runs in
idle
Air filter dirty
Clean or replace the air filter
Faulty spark plug
Replace the spark plug
Petrol engine does not
work in the stop position
Engine stop line defective
Interrupt the fuel supply line to stop the
engine, inspect the cable harness
Not grounded
Check ground contact
Petrol engine does not
have enough power
Air filter dirty
Clean or replace the air filter
Cylinder head gasket loose or seal
damaged
Remove the cylinder head gasket and
replace if necessary
Too little compression
Check the engine
Petrol engine produces a
lot of smoke when working
on steep slopes
Too much oil in the engine
Check the oil level, fill up to max. 75%