To Next PageTo Next PageHow to troubleshoot a battery error on a Kessel Control Unit?
To address a battery error on your Kessel Control Unit, check the battery charge state, ensure the connection is correct, and inspect the battery connection terminals for any damage.
How to fix a motor protection 1 or 2 error on a Kessel Control Unit?
If the Kessel Control Unit displays a 'Motor protection 1 or 2' error, set the current value according to the pump specifications. Remove any blockages that may be present. If the pump is defective, replace it. Also, check the mains for phase failure.
What to do if Kessel Water Pump has a power outage?
If your Kessel Water Pump experiences a power outage, it could be due to a general outage, a tripped miniature fuse (S1) within the unit, a tripped circuit breaker, or a defective main switch interrupting the mains supply cable. First, verify if it is a general power outage. Then, check the fuse, the main switch, and the mains cable. Also, consider that the control unit might have been deliberately switched off; refer to the "Switch on and off" section on page 36.
Why is my Kessel Water Pump showing a motor protection error?
A motor protection error on your Kessel Water Pump could be due to several reasons: the motor protection switch has tripped, it is set incorrectly, the pumping current is too high because of a faulty or blocked pump, or excessive current is caused by a phase failure. You should set the current value according to the pump specifications. Remove any blockage. If the pump is defective, replace it. Check the mains for phase failure.
How to fix a battery error on a Kessel Water Pump?
A battery error on your Kessel Water Pump may occur if the battery is missing, faulty, or if the voltage is less than 13.5V. Check the battery charge state, ensure the connection is correct, and inspect the battery connection terminals for any damage.
How to correct a rotating field error on a Kessel Control Unit?
If the Kessel Control Unit shows a rotating field error, swap two phases of the power cable.
What does temperature error 1a or 2a mean on my Kessel Control Unit?
If the Kessel Control Unit displays a temperature error 1a or 2a, the pump will restart automatically once the motor cools down, and the error message will be acknowledged automatically. If this error occurs frequently, consider replacing the pump.
What does temperature error 1b or 2b mean on my Kessel Control Unit?
If the Kessel Control Unit displays a temperature error 1b or 2b, the pump will remain inactive even after the motor has cooled down. You will need to switch the control unit off and then on again. If the error occurs frequently, consider replacing the pump.
What does alarm level mean on Kessel Water Pump?
An alarm level on your Kessel Water Pump indicates that a level exceedance has been detected. If this occurs frequently, check the design and performance of the pump(s).
What causes a level error in Kessel Water Pump?
A level error in your Kessel Water Pump can be caused by an incorrect layout or wiring of the probes, or the sensors in the control unit may be configured incorrectly. Perform a functional check as described in the system documentation.
General| Number of pressure pipes | 1 |
|---|---|
| Backflow preventer | Yes |
| Voltage | 400 V |
| Frequency | 50 Hz |
| Insulation class | F |
| Category | Control Unit |
| Operating mode | Intermittent |
| Phase | 3 |
