Kestrel Elite User Manual

25
Press only the sides of the impeller when removing and inserting
to avoid damaging the precision hub bearing. [
Figure 1] .
» Press FIRMLY on the impeller module to remove it.
» Insert the new impeller so the side that has the
small triangle (close to the perimeter) faces the
front of the Kestrel when installed.
Figure 1
IMPELLER REPLACEMENT
» Orient one “arm” of the module straight up .
[
Figure 2]. The impeller can be pushed in from
either side.
Figure 2
Shop for Quality products online at:
1.800.561.8187
www.SCOUTBASECAMP.ca

Kestrel Elite Specifications

General

Measurement Parameters	Wind speed, temperature, humidity, dew point, heat stress index
Wind Speed Accuracy	+/- 3% or +/- lowest significant digit, whichever is greater
Temperature Range	-20 to 158°F (-29 to 70°C)
Barometric Pressure Range	300 to 1100 hPa (8.85 to 32.5 inHg)
Barometric Pressure Accuracy	+/- 1.5 mbar
Connectivity	Bluetooth
Water Resistance	IP67 (waterproof to 1m for 30 minutes)
Operating Temperature	-29 to 70°C (-20 to 158°F)