Infrared Moisture Determination Balance Safety NotesFPL950701
Improper use of the infrared moisture tester in violation of the following safety notes may result in death, injury or damage to
property due to fire, etc. Furthermore, the infrared moisture tester has high temperature components which can cause burns
if proper safety guidelines are not followed.
Observe all safety guidelines
Carefully read and observe all safety notes included in this user’s manual.
Do not use the unit if it appears to be malfunctioning
If you suspect a problem or malfunction in the unit, discontinue use and immediately have the unit inspected by certified
Kett service personnel.
Meanings of Warning Indicators and Symbols
The following symbols are used in this operating manual and product to prevent accidents from occurring as a result of
improper usage or handling. The meaning of each symbol is as described below.
Failure to observe these items may lead to death or injury to the user.
Failure to observe these items may lead to injury to the user or damage to property.
Items which the user should be aware of in order to use the unit safely.
Caution Symbols Stop Symbols Symbols Requiring User Action
Fire Hazard Burn Hazard Electric Shock Prohibited Do Not Do not Expose Required Disconnect Plug
Hazard Disassemble to Water Action from Electrical Outlet
Do not attempt to measure samples which may undergo dangerous chemical reactions when heated, as doing so
may result in an explosion or release of toxic gas.
Do not place flammable materials near the infrared moisture tester.
Some parts of the infrared moisture tester become extremely hot during operation and could lead to a fire if
flammable materials are placed nearby.
Never use with any power source for which the product was not designed.
Application of excessively high voltage may result in overheating, malfunction, or fire.
Do not attempt to disassemble, modify or rebuild the infrared moisture tester.
Doing so may result in accident, electric shock, etc. If you believe the unit may be malfunctioning, take it to an
authorized Kett service center for service.
Do not allow the unit to come in contact with water.
The infrared moisture tester is not waterproof. Do not allow water or other liquids to get into the unit’s enclosure as
this may lead to electric shock or malfunction.
Do not touch the heat-dispersing component of the heater cover or sample dish with your bare hands, as doing
so might result in burns.
This infrared moisture tester is at high temperature during and immediately after making measurements. When
touching the unit, only use the specified control knobs and accessories.
Warning
Caution
Note
Warning
Fire Hazard Electric Shock Hazard
Caution
Burn Hazard Electric Shock Hazard
To Next Page
Loading...