65
15-2 Replacing Fuses
1 Remove the power cord from the unit.
2 The fuse holder is located at the rear of the unit.
Insert a slot screwdriver or similar tool from the top
of the fuse holder, and pull the fuse holder
towards your body.
3 Remove the fuses from the fuse holder and check
to see if any are burned out.
4 If there are no burned-out fuses, return the fuse
holder to its original position. If there is a burned-
out fuse, replace it with one of the spare fuses or
with a compatible (T8A 250V) fuse.
5 Return the fuse holder to its original position in the
main unit.
6 Insert the power cord back into the main unit.
* If a fuse blows out again after being replaced,
then there may be a problem with your unit,
and you should have it checked and/or
repaired.
To Next Page
Loading...