EasyManuals Logo

Keurig B100 Use & Care Guide

Keurig B100
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
2. Fill with Water
a. Lift the Water Fill Lid and hold
it open.
b. Fill the Brewer with up to 80 oz of water
on the initial fill (regular re-fill quantity
is 64 oz) by pouring water into the
Water Fill Area.
c. The Water Fill Indicator will be flashing
with a blue light while you are filling or
re-filling, and will stop flashing when
water passes the minimum fill level.
d. The Brewer will indicate that it has
reached the full water level with four
flashes of the Green "Ready" Light
and 4 audible beeps.
3. Perform Eight Cleansing Brews First
a. Place a mug on the Drip Tray Plate.
b. Open and close the Brew Drawer, green light
will flash.
c. Press the Brew Button and hot water will
dispense into the mug.
d. Pour hot water into the sink.
e. Repeat until brewer is empty.
4. Brew and Enjoy a Fresh Brewed Mug
a. Refill the brewer with water and allow
to heat.
b. Place a mug on the Drip Tray.
c. Open the Brew Drawer and insert
a K-Cup into the K-Cup Holder as
shown.
d. Close the Brew Drawer (flashing Green
“Ready” Light signals ready to brew).
e. Press the Brew Button to start
the brewing process.
f. After an air purge completes the
45 second brew process, open the
Brew Drawer and remove and dispose
of the used K-Cup.
g. Enjoy your fresh brewed coffee or tea!
h. Your Brewer is ready to brew your next mug.
Water Fill Area
Red “Not Ready” Light
Water Fill Indicator
Green “Ready” Light
K-Cup
K-Cup Holder
Brew Drawer
The Red “Not Ready” Light indicates
the Brewer is not ready (the water is
heating). Wait for 8 – 10 minutes.
The Green “Ready” Light will illuminate
when the water has reached the proper
temperature for brewing.
6
Water Fill Lid
NOTE: Do not remove the foil lid
or puncture the K-Cup.
NOTE: Remember, the Brew Button will
not work if the Green "Ready" Light is not
flashing. Open and close the Brew Drawer
to reactivate the Brew Button.
Brew Button
CAUTION: When refilling the Brewer,
it is possible for hot steam to escape.
Take care not to position your hand
directly over the Vent Port located on
the right side of the Water Fill Area.
Vent Port

Other manuals for Keurig B100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keurig B100 and is the answer not in the manual?

Keurig B100 Specifications

General IconGeneral
BrandKeurig
ModelB100
CategoryCoffee Maker
LanguageEnglish

Related product manuals