18 19
CLEANING THE BREWER EXTERIOR
Keep your Keurig
®
Plus Series brewer looking its best by
cleaning the exterior from time to time. Just clean with a
damp, soapy, lint-free, non-abrasive cloth. Never immerse
the brewer in water or other liquids.
CLEANING THE DRIP TRAY
The Drip Tray can accumulate up to 8 ounces of overflow.
The Drip Tray and the Drip Tray Plate should occasionally be
rinsed clean. To remove the Drip Tray, simply slide it toward
you, keeping it level at all times to avoid spilling. Clean with
a damp, soapy, lint-free, non-abrasive cloth.
CLEANING THE WATER RESERVOIR AND THE WATER
RESERVOIR LID
Clean the Water Reservoir and the Water Reservoir Lid
with a damp, soapy, lint-free, non-abrasive cloth and
rinse thoroughly.
Do not dry the inside of the Water Reservoir with a cloth
as lint may remain. Be sure to rinse the Water Reservoir
thoroughly after cleaning to ensure that no cleaning
solutions remain as they may contaminate the water
supply in the brewer. DO NOT PLACE THESE ITEMS
IN THE DISHWASHER.
CARING FOR YOUR BREWER
CLEANING THE POD HOLDER
1. Lift the Handle. Push up while grabbing
the sides of the Pod Holder Assembly.
Pull away from the brewer.
CAUTION: Sharp needles. Do not put fingers in chamber.
2. Pull out the Pod Holder Assembly (1) and
Base (2).
4. Clean the Pod Holder (1), Housing (2),
and Base (3) with a damp, soapy,
lint-free, non-abrasive cloth and
rinse thoroughly.
3. Press the release buttons on both sides
of the Pod Holder Assembly.
Separate the Pod Holder from
the Housing.
2
|
TIPS & MAINTENANCE
To Next Page
Loading...
Need help?
General
