20 21
CLEANING THE BREWER
ENTRANCE NEEDLE
Having trouble brewing? You may have
coffee grounds stuck in the brewer’s
Entrance Needle. Use your Brewer
Maintenance Accessory and get back to
brewing in a few quick steps!
NOTE: The Brewer Maintenance Accessory comes with the brewer.
It is an orange tool.
1. Please ensure the brewer is
powered off. With the printed text on
your Brewer Maintenance Accessory
facing up, fill silicon bulb with water.
3. Raise and lower the Handle five times to
loosen and remove any coffee grounds
retained in your brewer’s Entrance
Needle.
CARING FOR YOUR BREWER
2. Lift Handle, properly place Brewer
Maintenance Accessory in Pod Holder
with printed arrows pointing down.
Warning: Avoid sharp needles.
4. Remove Brewer Maintenance Accessory
from Pod Holder.
Warning: Avoid sharp needles.
5. Once you have removed the Brewer
Maintenance Accessory from the brewer,
power the brewer back on.
7. Brew your favorite Keurig
®
K-Cup
®
pod
and enjoy!
6. Place a 12-ounce mug on the Drip Tray
and perform a cleansing brew (refer
to page 11 for how to perform a
cleansing brew).
If you do not have this
accessory please contact
Keurig customer service at
1.800.361.5628.
2
|
TIPS & MAINTENANCE
To Next Page
Loading...
Need help?
General
