10 11
SETUP CLEANSING BREW
1. Place the brewer on a counter and plug
into a grounded outlet.
1. To begin a cleansing brew, place a
12 ounce mug on the Drip Tray.
3. Remove the Water Reservoir and rinse.
While removed, fill with bottled or
filtered water, and return to the brewer.
Be sure to fill below the MAX FILL line
and above the MIN FILL line.
NOTE: The reservoir only needs to be removed and filled for
the initial set up. After the first fill, you can refill the Water
Reservoir either while it is attached to the brewer or removed.
3. Press CONTINUE to dispense hot water.
Select a 8 ounce Brew Size and press the
Brew Button.
2. Lift the Handle, remove and discard the
shipping disk.
2. Lift and lower the Handle. Do not place a
Keurig
®
brand pod in the Pod Holder.
4. Press the Power Button and wait
for preheating to complete, about
three minutes.
4. You are now ready to use your brewer!
1
|
LET’S GET BREWING!
To Next Page
Loading...
Need help?
General
