EasyManuals Logo

Keurig K200 PLUS Series User Manual

Keurig K200 PLUS Series
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
22 23
CARING FOR YOUR BREWER
KEURIG
CARAFE OPERATION
The unique Keurig
Carafe was specifically designed for use with the Keurig
®
Plus Series
brewer. To connect the Keurig
Carafe to the brewer, make sure the Keurig
Carafe is
securely inserted into the brewer. The Keurig
®
Plus Series brewer contains a sensory system
that determines when the Keurig
Carafe is in place and it is safe to begin brewing. If the
Keurig
Carafe is not in place or is incorrectly inserted, the brewing process will not begin.
If the Keurig
Carafe is removed during brewing, brewing will stop.
To maintain the ideal combination of taste, freshness, and temperature, we recommend
preheating the Keurig
Carafe. To preheat the Keurig
Carafe, fill it with hot water for
approximately 30 seconds and then pour out entirely prior to placing the Keurig
Carafe
into the brewer.
CAUTION:
Make sure the Keurig
Carafe is empty before each use.
After brewing, the Keurig
Carafe will contain extremely hot liquid. Take care when
pouring from the Keurig
Carafe. Never place your hand over the Keurig
Carafe
where hot steam is venting. Never allow children to use the Keurig
Carafe or operate
the brewer without adult supervision. Press the Power button to terminate the brew
process. Follow the instructions on the Touch Display before removing the Keurig
Carafe. The brewer will return to the home screen. Remove and discard the used
K-Carafe
TM
pod.
There is extremely hot water in the Pod Holder during the brew process.
To avoid risk of injury, do not lift the Handle during the brewing process.
HAND-WASH ONLY. DO NOT SUBMERGE. DO NOT MICROWAVE.
NOTE: CARAFE NOT INCLUDED WITH BREWER.
2
|
TIPS & MAINTENANCE
CLEANING THE EXIT NEEDLE
1. If a clog arises in the Exit Needle, push
the lever of the Pod Holder to reveal the
Exit Needle.
2. Use a paper clip or similar tool to
loosen the clog. Rinse thoroughly
with hot water.
3. After all the pieces are cleaned, place the
Base then the Pod Holder assembly into
the Brew Head. Lower the Handle.
CAUTION: Sharp needles. Do not put fingers in chamber.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keurig K200 PLUS Series and is the answer not in the manual?

Keurig K200 PLUS Series Specifications

General IconGeneral
BrandKeurig
ModelK200 PLUS Series
CategoryCoffee Maker
LanguageEnglish

Related product manuals