Integrated Systems Wiring: KD-PS42 with KD-Amp220 and KD-CamUSB
Configure
Configure KD-PS42 with Key Digital Management Software Pro (KDMS Pro). Download HERE
1. Connect to KD-PS42 from your PC using the USB micro port on the face of the unit
2. Open the KDMS Pro software and perform a USB scan (fig. 1a). Choose “NO” and Start Scan when the
USB Device Scan prompt appears (fig. 1b
3. Choose the detected device from the Devices window (fig. 2a)
4. Set the desired Device Name in the KD-PS42 Information window (fig. 2b)
5. In the Network Settings section of the Properties window, enter the desired IP settings (fig. 2c)
a. IP Address (default is 192.168.1.239)
b. Subnet Mask (default is 255.255.255.0)
c. Gateway (default is 192.168.1.1)
d. Port (default is 23)
e. Note: If using KD-
App, please do
not change the
port number.
6. Save (fig. 2d)
To Next Page
Loading...
