KEYBOARDPARTNER HX3 - Rotary Simulation Settings; Rotary Motor, Speed, and Bypass

HX3.5 Mainboard 15
Rotary Setup
Rotary Motor: RUN/STOP switch of the rotary simulation.
Rotary Fast: SLOW/FAST switch of the rotary simulation.
Bypass: Switching off the rotary simulation.
The Rotary Setup menu items have a common submenu:
 HornSlowSpeed: Rotation speed of the horn in SLOW position.
 RotrSlowSpeed: Rotation speed of the rotor in SLOW position.
 HornFastSpeed: Rotation speed of the horn in FAST position.
 RotrFastSpeed: Rotation speed of the rotor in FAST position.
 HornRampUp: Horn ramp up time.
 RotorRampUp: Rotor ramp up time.
 HornRampDown: Horn runout time
 RotorRampDown: Rotor runout time.
 Rotary Throb: Microphone placement.
 Rotary Spread: Stereo width.
 Rotary Balnce: Level balance between rotor and horn.
Percussion Setup
Percussion: Percussion selection stepwise in all possible combinations of NORM/SOFT,
FAST/SLOW, 2nd/3rd (not for H100) and OFF. This menu is not active when EnvelopeGen mode
is set. Then only (EG ADSR) appears to indicate that a percussion effect can be achieved here by
shaping the ADSR envelope.
 PercNormLvl: Level in position NORMAL.
 PerSoftLvl: Level in position SOFT.
 PercLongTm: Decay time in position LONG.
 PercShortTm: Decay time in position SHORT.