10
Getting Started
STEP 3. Install the Software
Power Up the Controller
If you are using a remote controller, complete the following steps:
1. Install the cable interface between the remote controller and the chassis. If
you are using an Keysight M9021A cable interface, refer to the Keysight
M9021A documentation for further details.
2. Power up the chassis.
3. Power up the PC.
CAUTION If you are using a remote controller and you have installed the interface cable, you must
power up the chassis BEFORE you power up the PC.
When you power down your system, shut down the PC BEFORE you power down the
chassis.
If you are using an embedded controller, complete the following steps:
1. Install the embedded controller module into a compatible chassis. The
Keysight M9018A PXIe chassis is recommended. Refer to the Keysight
M9018A documentation for further details.
2. Connect peripherals (mouse, keyboard, monitor).
3. Power up the chassis.
Software Installation Overview
The software installation includes the following items:
• Keysight IO Libraries Suite (IOLS), which includes the Keysight Connection
Expert. This software is included with your shipment (CD part number
E2094-60003), and the latest version is available at
www.keysight.com/find/iosuite. This software must be installed first.
NOTE Version 16.3.17914.4 (or newer) of the Keysight IO Libraries Suite is required.
• Network analyzer module software, which includes the soft front panel
(SFP) software, device drivers (IVI-C and IVI-COM, and LabVIEW G), and
documentation for the M937xA PXIe Vector Network Analyzer modules.
This software is included with your shipment (CD part number
M9370-90003) and is also available at
http://na.support.keysight.com/pxi/firmware.
To Next Page
Loading...
Need help?
General
