N9030B PXA Signal Analyzer Service Guide 93
Instrument Messages
Advisory Messages
Span is not coupled to RBW
when EMI detector is selected
Sweep Points/Span is <
minimum. Results may be
inaccurate.
The sweep point to span ratio is below the minimum required to ensure the
bucket ratio is large enough to test DVB-T masks
Sweep Setup is not available
in Zero Span
Zero span is a display at a single frequency, so there is no “sweeping” to
set up.
Sync is RF Ampl (not Training
Sequence). Bits are not
accurate.
Trace file saved. The trace saving operation was successful.
Use Gate View Sweep Time in
the Gate menu.
When in Gate View you use Gate View Sweep Time, rather than Sweep
Time, to control the Gate View window
User Cal valid. Apply Cal
from Meas Setup menu
The measurement setup has changed such that the current cal data can be
applied to the results. To apply the cal, press Meas Setup/Cal Setup/Apply
Calibration. A new cal can be performed if required.
Message Description/Correction Information
To Next Page
Loading...
Need help?
General
