Keysight E4991B - Page 2

02 | Keysight | E4991B Impedance Analyzer - Conguration Guide
Ordering Guide
The following steps will guide you through conguring your E4991B.
Standard furnished item
Description Additional Information
Installation guide
Contains the information necessary to start up with the E4991B.
CD ROM IO libraries
7-mm calibration kit with torque wrench
Contains Open, Short, 50 Ω Load and Low-loss Capacitor terminations and torque wrench.
Power Cable
Certicate of Calibration
Note: The following are not furnished: Printed copy of Operation and Service Manual, Test Fixture, Keyboard and Mouse. Refer to Accessory Option, Documentation Option
and Available Accessories for the selection of these items.
Note: The test head is furnished with the E4991B main unit.
Step 1. Choose hardware option - frequency (mandatory)
Description Option No. Requires Not Compatible Additional Information
1 MHz to 3 GHz E4991B-300 None None
1 MHz to 1 GHz E4991B-100 None None
1 MHz to 500 MHz E4991B-050 None None
Step 2. Choose hardware option – frequency reference if not required, go to Step 3)
Description Option No. Requires Not Compatible Additional Information
High Stability
Frequency Reference
E4991B-1E5 None None Adds High Stability
Frequency Reference
Note: Refer to Hardware Upgrade for retrot information on the above options.
Step 3. Choose hardware option – DC bias (If not required, go to Step 4)
Description Option No. Requires Not Compatible Additional Information
DC Bias Source E4991B-001 None None Adds DC Bias Source.
Note: Refer to Hardware Upgrade for retrot information on the above options.
Step 4. Choose software option (If not required, go to Step 5)
Description Option No. Requires Not Compatible Additional Information
Material Measurement
Firmware
E4991B-002 None None Adds Material Measurement Firmware for permittivity and
permeability measurements. This option is required to use the
16453A and 16454A.
Note: Refer to Software Upgrade for retrot information on the above options.