Page 3
Find us at www.keysight.com
Step 3. Choose hardware option (If not required, go to step 4)
Option No. Description
E5061B-1E5
1
Add High stability time base
E5061B-721 Add GPIB interface (must choose either Option 721 or 722)
E5061B-722 Without GPIB interface (must choose either Option 721 or 722)
E5061B-731 Add handler I/O interface (must choose either Option 731 or 732)
E5061B-732 Without handler I/O Interface (must choose either Option 731 or 732)
Step 4. Choose storage option
2
Option No. Description
E5061B-020 Standard hard disk drive
Step 5. Choose software option (If not required, go to step 6)
Option No. Description
E5061B-010
3
Time domain/fault location analysis
E5061B-006
4
Wireless power transfer analysis
Step 6. Choose accessory option (If not required, go to step 7)
Option No. Description
E5061B-810 Add keyboard
E5061B-820 Add mouse
E5061B-1CM Rack mount Kit
E5061B-1CN Front Handle Kit
E5061B-1CP Rack mount and front handle kit
Step 7. Choose calibration option (if not required, go to step 8)
Option No. Description
E5061B-1A7 Calibration + Uncertainties + Guardbanding
E5061B-A6J ANSI Z540-1-1994 Calibration
1. Refer to “Hardware upgrade” section for retrofit information on the above options.
2. Option 020 is the only storage option for the E5061B. Must choose this option when ordering the E5061B.
3. Refer to “Software upgrade” section for retrofit information on the above option.
4. This option is not applicable for the E5061B 75 ohm test set options 1x7/2x7 and Transmission/Reflection test set options 1x5.
To Next Page
Loading...
Need help?
General
