Setting Up the Oscilloscope 1
Keysight Infiniium S-Series Oscilloscopes User’s Guide 23
Turning Off the Oscilloscope
To turn the oscilloscope off, press the power switch at the lower left corner of the
oscilloscope front panel. The oscilloscope will go through a normal Windows
operating system shutdown process.
Cleaning the Oscilloscope
Clean the Infiniium oscilloscope with a soft dry cloth or one slightly dampened
with a mild soap and water solution to clean the external case parts. Do not
attempt to clean internally.
To avoid electrostatic discharge (ESD), wear a grounded wrist strap when cleaning
connectors.
To prevent electrical shock, disconnect the Infiniium oscilloscope from mains before
cleaning.
Do not use too much liquid in cleaning the oscilloscope. Water can enter the Infiniium
panels, damaging sensitive electronic components.
Use alcohol to clean connectors. The power cord must be removed, and the
oscilloscope must be in a well-ventilated area. Allow all residual alcohol moisture to
evaporate, and the fumes to dissipate prior to powering up the oscilloscope. Dispose
of the cleaning materials in a responsible manner.
To Next Page
Loading...
