104 Keysight InfiniiVision DSOX1204A/G Oscilloscopes User's Guide
Index
color printing, 85
color screen image, 82
compensate passive probes, 18, 25
Config softkey, 89, 90, 91
Conformity, Declaration of, 96
connection, to a PC, 91
connectors, rear panel, 26
control, remote, 87
controls, front panel, 20
copyright, 2
count measurements, 64
Counter measurement, 64
counters, CAN, 77
counters, UART/RS232, 81
coupling, channel, 37
coupling, trigger, 52
crash log export, 88
crosstalk between input channels,
minimizing, 36
crosstalk problems, 40
CSV file format, 83
cursor measurements, 61
cursor units, 62
Cursors key, 22
Cursors knob, 22
cursors, binary, 62
cursors, hex, 62
cursors, manual, 62
cursors, track waveform, 62
cutoff frequency, low-pass filter, 45
D
damage, shipping, 12
data sheet, 95
date, 88
DC channel coupling, 37
DC RMS measurement, 64
DC signals, checking, 52
DC waveform generator output, 75
decibels, FFT (Magnitude) vertical
units, 45
decibels, FFT vertical units, 40
decimating samples, 60
Declaration of Conformity, 96
decode, CAN serial bus, 77
decode, I2C serial bus, 78
decode, LIN serial bus, 78
decode, SPI serial bus, 79
decode, UART/RS232 serial bus, 80
default configuration, 16
default label library, 47
default setup, 16
Default Setup key, 21
defaults, waveform generator, 75
degrees, FFT (Phase) vertical units, 45
Delay measurement, 64
delay time, 34
delete file, 87
Demo terminal, 25
DHCP, 90, 91
digital voltmeter (DVM), 72
digital voltmeter mode, 72
Display key, 23
display multiple acquisitions, 32
display, area, 27
display, interpreting, 27
display, persistence, 47
display, single-shot infinite
persistence, 47
display, softkey labels, 28
display, status line, 27
displayed channels AutoScale, 88
distortion problems, 40
Divide math function, 44
DNS IP, 90
Duty cycle - measurement, 64
Duty cycle + measurement, 64
DVM (digital voltmeter), 72
Dynamic DNS, 90
E
edge speeds, 59
edge triggering, 51
EEPROM data read, I2C trigger, 78
eject USB mass storage device, 87
eject USB storage device, 87, 91
entire display, FFT (Phase) zero phase
reference, 45
Entry knob, 21
Entry knob, push to select, 21
environmental conditions, 96
erase, secure, 83
error action, mask test, 65
exFAT file system format not
supported, 91
expand about, 24, 87
expand about center, 87
expand about ground, 87
exporting waveform, 82
Ext Trig as Z-axis input, 34
Ext Trig input connector, 26
EXT2 file system format, 91
EXT3 file system format, 91
EXT4 file system format, 91
external memory device, 25
external trigger, 53
external trigger, input impedance, 53
external trigger, probe attenuation, 53
external trigger, probe units, 53
external trigger, range, 53
external trigger, threshold, 53
F
factory default settings, 83
Fall time measurement, 64
Falling Edge Count measurement, 64
fast debug AutoScale, 88
FAT file system format, 91
FAT16 file system format, 91
FAT32 file system format, 91
FFT (Magnitude), FFT (Phase) vertical
units, 45
FFT aliasing, 42
FFT DC value, 42
FFT key, 24
FFT magnitude math function, 44
FFT measurement hints, 40
FFT phase math function, 44
FFT resolution, 41
FFT spectral analysis, 40
FFT spectral leakage, 43
FFT vertical units, 40
FFT window, 40
file explorer, 87
file format, ASCII, 83
file format, BIN, 83
file format, BMP, 82
file format, CSV, 83
file format, PNG, 82
file, save, recall, load, 87
filter, low pass, 44
fine adjustment, vertical scale, 37
firmware updates, 98
firmware version information, 93
To Next Page
Loading...
