used improperly as handles to push, pull, or carry a load module.
Do not use ejector tabs as handles to support a load module while installing and fitting into the
chassis. The ejector tabs are to be used only to eject the module from the chassis backplane
connector.
Maintenance Instructions
The only user maintainable feature is changing the fuse, if it blows. Replace the fuse only with one of
the same size and rating. The fuse drawer, located near the power cord receptacle, pulls out with a
small flat-bladed screwdriver. Note that repeated fuse blowing may likely indicate some internal
problem; you should report the problem to Ixia Technical Support.
We recommend cleaning of the ventilation intake grills periodically to permit good airflow intake.
Calibration of the Ixia chassis is not required. There are no adjustable components in any Ixia chassis.
China RoHS Declaration
The China RoHS Declaration can be found in the Ixia Platform Reference Guide, in the Chapter titled
About This Guide.
Cautions
XM12 Caution
The following cautions and warnings apply to the XM12 chassis.
The socket/ outlets used to power the unit must be installed near the equipment and must be easily
accessible because the power plug may be used to disconnect the unit from the power source.
Chapter 2 Installation
– 7 –
To Next Page
Loading...