Computer Configuration
Windows Settings
Security Settings
Local Policies
Security Options
6. Right-click unsigned driver installation behavior and click Security.
7. Change the Local policy setting to Silently succeed.
8. Click OK.
Note: It is necessary to restart the chassis after this operation.
IxOS Silent Install by .exe Package
Setting up the silent install for IxOS for a chassis involves activating specific features included in the
product package, and specifying the server operation mode through a command prompt.
The available features and properties (operation modes) are delivered as part of the installer. Table:
Features lists the features available, and Table: Properties lists the properties.
To run the IxOS installer silently, use the IxOS<version>.X.X.exe package, where <version> is the
version of the software, and X.X is the build number for the particular package. The command line to
extract the setup is like “IxOS_X.XX_EA.exe /s /extract-only". It caches to location \Program
Files\IxiaInstallerCache\IxOS\X.X.X.X where X.X.X.X is the build number. The setup.exe file is located
in this folder.
The following steps demonstrate how to set up silent installation through the .exe package.
1.
Open a command prompt.
2.
Enter the following command argument, in one line:
setup.exe [-s|-q] [-n] [i|x|r] [F.Feature1=Yes|No [F.Feature2=Yes|No]]
[P.Prop1=Val1 [P.Prop2=Val2]]
See IxOS setup.exe Package Example below for examples of using the command prompt to set up
silent installation.
Switch Definition
-s silent (progress bar only)
-q quiet (no GUI at all)
-n external controlled (by IxAdmin)
Table: setup.exe Switches
Chapter 2 Installation
– 62 –
To Next Page
Loading...