Figure: Default Internet Protocol (TCP/IP) Properties
5.
This setting reflects the default factory setup for your chassis. It is configured to use DHCP to
discover all network aspects for your chassis. If you have a DHCP server computer on the network
attached to the chassis, this is the appropriate configuration of your chassis; proceed to step 11.
If no DHCP server computer is found on the network, Windows 7 automatically assigns a unique
IP address in the 169.254.0.0–169.254.255.255 range. Again this might be appropriate for your
network. If you need to assign a particular IP address to your chassis, fill in the fields as shown in
the following figure and explained in Table: Internet Protocol (TCP/IP) Settings
Figure: Internet Protocol (TCP/IPv4) Properties for a Static Address
Chapter 2 Installation
– 22 –
To Next Page
Loading...