ii. Click Change time zone and adjust the time zone and daylight savings time settings as
appropriate, as shown in the following figure. Return to the Date and Time tab to set the
current time in your time zone.
Figure: Date and Time Properties: Time Zone Settings
3.
An NTP (Network Time Protocol) service automatically runs. If your chassis is connected to the
Internet, it keeps the system clock on your chassis accurate. If your chassis is not connected to
the Internet, the NTP service has no adverse effects.
4.
An anti-virus scanner is installed, but it does not run a scheduled full system scan.
Chapter 2 Installation
– 27 –
To Next Page
Loading...