Keysight N6705 - Page 103

Disassembly 4
Model N6705 Service Guide 103
Removing/Installing the Front Panel PCA
Step 1.
Remove the sub panel as previously described.
Step 2.
Remove the display as previously described.
Step 3.
Disconnect the binding post PCA to front panel PCA ribbon cable
and remove seven screws using a T10 driver.
Figure 4-37
Step 4.
Remove the seven knobs from the front panel.
Figure 4-38
Step 5.
Remove the front panel PCA.
Step 6.
To install the front panel PCA, perform steps 1-5 in reverse order.