Need help?Do you have a question about the Keysight N1911A and is the answer not in the manual?
General| Power Measurement Range | -70 dBm to +44 dBm |
|---|---|
| Number of Channels | 1 |
| Measurement Speed | Up to 1000 readings per second |
| Measurement Accuracy | ±0.5% (typical) |
| Display | Color LCD |
| Interface | USB, LAN |
| Power Supply | AC 100-240 V, 50/60 Hz |
| Battery Operation | No |
| Power Sensor Compatibility | Keysight 8480 Series, E-Series, N8480 Series |
| Frequency Range | 9 kHz to 110 GHz |
Details the compatibility of the P-Series power meter with various Keysight power sensors, highlighting feature differences.
Details how to apply channel, frequency-dependent, or display offsets to compensate for signal loss or gain.
Explains how to use digital filtering to average power readings, reduce noise, and improve results.
Describes how to set up to four gates to obtain measurement data from a captured trace.
Explains how to configure trace display settings, including X/Y axis, units, and scale.
Details how to configure trigger sources, modes, hold-off, hysteresis, and delay for stable measurements.
Explains how to configure upper and lower limit values to detect measurement deviations.
Provides instructions on how to perform zeroing and calibration for P-Series wideband power sensors.
Guides users on configuring measurements using trace display menus like Gate Control and Trace Control.
Guides users on setting up the trace display for pulsed signal measurements with E9320 sensors.
To Next Page
