Introduction 1
Keysight N1911A/1912A User’s Guide 51
An example of the Web browser is shown in Figure 1-9.
Figure 1-9 N1912A P-Series power meter Web browser (Welcome Page)
Instrument on the network can be physically identified through the Status
message on Remote Interfaces screen by clicking Toggle ID within the Web
browser. This changes the status of the Instrument ID to ON or OFF.
Before the instrument identification starts, press
, to
view the Status message.
When Instrument ID is toggled to ON, this causes the Status message
“LAN identify start” in Remote Interface screen on the front panel to blink 3 times.
When the Toggle ID is selected again, the default Status message “Running” is
returned. See Figure 1-10 and Figure 1-11.
To Next Page
Loading...
