Keysight N1911A

Introduction 1
Keysight N1911A/1912A User’s Guide 31
Power Meter and Sensor Capability
Your P-Series power meter is compatible with Keysight P-Series, E-Series E9320,
E-Series E9300, E-Series E4410, 8480 Series and the N8480 Series power
sensors. However, not all sensor and meter combinations have the same features
or capabilities. The main differences are as below:
Specifications
The specifications for the power meter are listed in Chapter 11, "Specifications
and Characteristics".
Features
P-Series
N1920
E-Series
E9320
E-Series
E9300
E-Series
E4410
8480 Series
N8480
Series
Average power of CW signal * * * * * *
Average power of modulated signal * * * * *
Peak power * *
Cal factors stored on EEPROM * * * *
*
[a]
>200 readings/sec * * * *
Peak/burst average power * *
Time gated measurements * *
Rising edge trigger * *
Falling edge trigger * *
[a] Not applicable for N8480 Series power sensors with Option CFT
NOTE
– The E-Series, 8480 Series and N8480 Series power sensors require N1917A/
B/C/D cables when connected to the P-Series power meters.
– The N8480 Series power sensors used in this user’s guide is referring to all
sensors from the N8480 Series unless otherwise stated.