Note:
When one of the above malfunctions occurs, turn o the unit,
and check for any obstructions. Restart the unit, if the malfunction is
still present, turn o the unit and unplug the power cord. Contact the
manufacturer or its service agents or a similar qualified person for
service.
Glows when the bucket is ready to be emptied.
When forst builds up on the evaporator coils, thecompressor will
cycle o and the fan will continue to run until the frost disappears.
The humidity level can be set within a range of 35% RH(Relative
Humidity) to 85%RH(Relative Humidity) in 5% increments. For drier
air , press the (or ) button and set to a lower percent
value(%). For damper air, press the (or ) button and set a
higher percent value(%).
11.UP/DOWN buttons
Humidity Set Control buttons
TIMER Set Control buttons
Use the Up/Down buttons to set the Auto start and Auto stop time
from 0.0 to 24.
Shows the set % humidity level from 35% to 85% or auto start/stop time
(0~24) while setting, then shows the actual(±5% accuracy) room %
humidity level in a range of 30% RH(Relative Humidity) to 90%RH
(Relative Humidity).
Error Codes and Protection Code:
AS-Humidity sensor error--Unplug the unit and plug it back in. If error
repeats, call for service.
ES-Tube Temperature sensor of the evaporator error-- Unplug the unit
and plug it back in. If error repeats, call for service.
P2-Bucket is full or bucket is not in right position-- Empty the bucket
and replaceit in the right position.(only available for the unit with no
pump feature.)
P2-Bucket is full -- Empty the bucket.
(only available for the unit with pump feature.)
Eb-Bucket is removed or not in right position-- Replace the bucket in
the right position.(only available for the unit with pump feature.)
Press to activate the dryer operation. Press it again to stop the
function.
Display
DRYER button
9.Auto Defrost
10.Bucket Full Light
To Next Page
Loading...
Need help?
General
