Get to know your features
Operation Display
NOTE
Control Panel Features
The following control panels are for explanation purpose only. The control panel of the unit you purchased may be slightly
dierent according to the models. Your machine may not contain some indicators or buttons. The actual shape shall prevail.
Press to activate the continuous dehumidifying operation.
4.CONTINUE button
Press to initiate the Auto start and Auto stop feature, in conjuction
with the and (or and ) buttons.
2.Timer button
1.POWER button
Press to turn the dehumidifier on and o.
5.FILTER button
6.WIRELESS button
Press the filter button for 3 seconds when the unit is on or o to initiate
the Wireless connection mode. The LED DISPLAY shows ‘AP’ to indicate
you can set Wireless connection and the compressor is forced o. If
connection (router) is successful within 8 minutes, the unit will exit Wire-
less connection mode automatically and the Wireless indicator illuminates
and the compressor reverts previous state. If connection is failure within 8
minutes, the unit exits the Wireless connection mode automatically.
The check filter feature is a reminder to clean the Air Filter for
more ecient operation. The Filter light(Clean filter light) will
illuminate after 250 hours of operation.To reset after cleaning the
filter, press the Filter button and the light will go o.
3.TURBO Pad
Control the fan speed. Press to select either High or Normal fan
speed. Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
preferred, set the fan control to Normal.
Note:
On this operation,the unit can not be set humidity level.For some
models, under comfortdehumidifying operation, press Up/Down button
will cancel this feature.
7.COMFORT button
Press to activate the comfort dehumidifying operation.
145/6 7 2 113
9
10
To Next Page
Loading...
Need help?
General
