Keystone KSTAD504F User Manual

Pour the water out.
Pump the hose drops.
Reinstall pump
hose properly
When you remove the bucket, do not touch any parts inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the unit. Banging the bucket against anything or failing to push it in securely may cause the
unit not to operate.
If the pump hose drops when you remove the bucket, you must reinstall the pump hose properly to the unit before replace the bucket into
the unit.
When you remove the bucket,if there is some water in the unit you must dry it.
When the unit is on, if the bucket is removed, the compressor and the fan turn o, then the unit will beep 8 times and the digital display
shows Eb.
When the unit is o, if the bucket is removed, the unit will beep 8 times and the digital display shows Eb.
Water can be automatically emptied into a floor drain by attaching the unit with a water hose(ld≥Φ5/16", not included) with a female threaded
end(ID:M=1",not included)
Note: On some models, the female threaded end isinclude.
Remove the plastic cover from the back drain outlet of the unit and set aside, then insert the drain hose through the drain outlet of the unit and
lead the drain hose to the floor drain or a suitable drainage facility.
NOTE
3
Type 2
The dumping of waste water.
water hose drainage (continuous)
16

Keystone KSTAD504F Specifications

General

Brand	Keystone
Model	KSTAD504F
Category	Dehumidifier
Language	English