Features of your vehicle
1284
Wipers and washers
僅 Do not put pressure on the windshield
glass.
僅 When washing the vehicle, set the
wiper switch in the OFF (0) position to
stop the auto wiper operation.
The wiper may operate and be dam
-
aged if the switch is set in the AUTO
mode while washing the vehicle.
僅 Do not remove the sensor cover
located on the upper end of the pas
-
senger side windshield glass. Damage
to system parts could occur and may
not be covered by your vehicle war
-
ranty.
僅 When starting the vehicle in winter,
set the wiper switch in the OFF (0)
position. Otherwise, wipers may oper
-
ate and ice may damage the wind
-
shield wiper blades. Always remove all
snow and ice and defrost the wind
-
shield properly prior to operating the
windshield wipers.
僅 When tinting the windshield, be care
-
ful of any fluid getting into the sensor
located in the top center of the front
windshield. It may damage the related
parts.
Operating rear window wiper and
washer switch
The rear window wiper and washer
switch is located at the end of the wiper
and washer switch lever.
僅 Turn the switch to the desired position
to operate the rear wiper and washer.
- HI - Normal wiper operation
- LO - Intermittent wiper operation
- OFF - Wiper is not in operation
僅 Push the lever away from you to
spray rear washer fluid and to run the
rear wipers several times.
The spray and wiper operation will con
-
tinue until you release the lever.
When the front wiper is activated and
the gear is switched to R (Reverse) posi
-
tion, the rear wiper will be activated once
to provide better visibility.
To Next Page
Loading...
