75
6
6
Driver assistance system Cruise Control (CC)
To resume Cruise Control
Operate the +, - switch or ( ) button.
If you push the + switch up or - switch
down, vehicle speed will be set to the
current speed on the cluster.
If you press the ( ) button, vehicle
speed will resume to the preset speed.
Vehicle speed must be above 30 km/h
(20 mph) for the function to resume.
Check the driving condition before using
the ( ) button. Driving speed may
sharply increase or decrease when you
press the ( ) button.
To turn off Cruise Control
Press the Driving Assist button to turn
Cruise Control off. The Cruise
( ) indicator will go off.
Always press the Driving Assist button to
turn Cruise Control off when not in use.
Take the following precautions when
using Cruise Control:
僅 Always set the vehicle speed under
the speed limit in your country.
僅 Keep Cruise Control off when the
function is not in use, to avoid inad
-
vertently setting a speed. Check that
the Cruise ( ) indicator is
off.
僅 Cruise Control does not substitute for
proper and safe driving. It is the
responsibility of the driver to always
drive safely and should always be
aware of unexpected and sudden sit
-
uations from occurring.
僅 Always drive cautiously to prevent
unexpected and sudden situations
from occurring. Pay attention to the
road conditions at all times.
僅 Do not use Cruise Control when it may
be unsafe to keep the vehicle at a
constant speed:
- When driving in heavy traffic, or
when traffic conditions make it dif
-
ficult to drive at a constant speed
- When driving on rainy, icy, or snow-
covered roads
- When driving on hilly or windy
roads
- When driving in windy areas
- When driving with limited view
(possibly due to bad weather, such
as fog, snow, rain and sandstorm)
僅 Do not use Cruise Control when tow
-
ing a trailer.
To Next Page
Loading...
