12
Step 5: Lift the control hub into position and insert the 6 bolts and washers into the pre drilled
holes. Secure with a nut and washer on the rear. Tighten with a spanner until secure.
Step 4: Using a 6mm drill bit, drill through the 6 premarked holes on your mounting surface.
Note: if mounting on a metal surface you may need to use a smaller pilot hole or step drill.
Step 3: Locate the position in your vehicle where you will be mounting your control hub.
Making your own template, mark the 6 holes on your mounting surface. Lift the control hub
into place to ensure these marks align with the 6 pre drilled holes in the control hub
To Next Page
Loading...