24
NON DCDC CHARGER MODEL
The following information only applies to the KickAss Control Hubs fitted without a DCDC
Charger.
MOUNTING ITEMS ON THE CONTROL HUB
Other auto electrical accessories can be retrofitted to the control hub making use of the
free space. The following precautions should be taken when mounting other equipment:
● Prior to drilling through the front face of the control hub, please be wary of hardware
and wiring that may be located on the rear side of the face panel
● There are several blank holes covered by the sticker on the front face, you can use
these holes for mounting equipment. You can locate these holes be looking at the rear
side of the face panel, they have also been shown in the image below
● Mounting a DCDC charger to your control hub will not affect your warranty, unless it is
determined to be the cause of the failure.
Step 8: Tuck cables neatly under the control hub and carefully close the lid, returning the
4 screws to secure the control hub down
To Next Page
Loading...