21
ROTATING THE DCDC CHARGER
The KickAss Control Hub has been designed to allow the DCDC charger to be rotated.
What You Will Need
Flat Head
Screwdriver
Adjustable
Spanner
Phillips Head
Screwdriver
Note: Ensure the unit is disconnected from the battery prior to attempting any wiring
Note: It is recommended to take a photo prior to removing wires to ensure all wires are
put back in the correct position
Step 1: Using the supplied allen key, remove the 4 screws and open the Control Hub
Step 2: Remove the wires from the solar (Green and Black) and alternator (Red, Black
and Blue) Anderson style plugs. Note: Do not pull to hard on the wire as this may
damage the unit
Insert a flat head screwdriver into
the front of the Anderson style plug
Push down the spring clip below
the lug pin to release
Step 3: Unbolt the DCDC output wires (one brown and two black) from the positive (red)
and negative (black) terminal post
REMOVE
THESE WIRES
Apply a light pulling force on the wire
To Next Page
Loading...