14
Step 4: If your wiring is dual core, separate
approximately 30cm of the two wires.
Note: You may need to remove the 30cm
of the outer layer of insulation if your wire
is double insulated
Step 5: Strip approx 1cm of insulation from
each cable using a wire stripper, select and
crimp the appropriate sized spade terminal
to your positive wire and the ring terminal
to the negative wire. Note: Check with the
manufacturer of your accessory to
determine which wire is positive and which
is negative crimping terminals.
Step 6: Connect the spade terminal to the bottom blank tab on your switch and using a
phillips head screwdriver, connect the negative ring terminal to one of the spare screw
positions on the negative bus bar.
30cm
1cm
Step 8: Tuck cables neatly under the control hub and carefully close the lid, returning the
4 screws to secure the control hub down
To Next Page
Loading...