Need help?Do you have a question about the Kicker BX360.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Power Output (RMS) @ 2 ohms | 90W x 4 |
| Power Output (RMS) Bridged @ 4 ohms | 180W x 2 |
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 95 dB |
| Minimum Impedance Unbridged | 2 ohms |
| Minimum Impedance Bridged | 4 ohms |
| Input Voltage | 14.4V |
| Input Sensitivity | 200 mV - 4V |
| Crossover | Low-pass and high-pass |
Compares RMS power output for BX360.4 and BX500.4 models across various impedance loads.
Details common specifications like dimensions, frequency response, signal-to-noise ratio, and input sensitivity.
Describes common amplifier features such as selectable electronic crossover and bass boost.
Guidance on selecting a suitable location and physically securing the KICKER amplifier.
Detailed steps for connecting power, ground, and signal wires to the amplifier.
Critical safety advice regarding input usage and electrical connections.
Wiring diagram for utilizing all four channels independently for stereo output.
Wiring diagram for connecting speakers in bridged mono configuration for increased power.
Wiring diagram for simultaneous stereo and mono operation modes.
Explains RCA vs. Hi-Level inputs and setting the input mode (4CH/2CH).
Instructions for adjusting input gain, bass boost, and crossover frequency.
Details how to set the crossover type (OFF, LP, HP) for filtering signals.
Instructions for connecting and using the optional BXRC remote bass level control.
Diagnosing problems when the amplifier is not powering on or producing sound.
Explains reasons for the red protection LED, including thermal and voltage issues.
Steps to diagnose and fix issues with a single channel not working.
Addresses alternator noise, ground noise, and poor stereo image or bass response.
Notes on speaker impedance and important precautions for jump starting.
To Next Page
