To Next PageTo Next Page
Need help?Do you have a question about the Kicker CXA600.5 and is the answer not in the manual?
General| Channels | 5 |
|---|---|
| Power Output (RMS) | 600 Watts |
| Frequency Response | 10 Hz - 20 kHz |
| Input Sensitivity | 200 mV - 4 V |
| Signal to Noise Ratio | > 95 dB |
| Bridged Power (4 Ohms) | 300 Watts x 2 |
| RMS Power @ 4 Ohms | 50 Watts x 4 + 300 Watts x 1 |
| RMS Power @ 2 Ohms | 75 Watts x 4 |
| Bridged RMS Power @ 4 Ohms | 150 Watts x 2 + 600 Watts x 1 |
| Impedance | 4 Ohms |
| Crossover | High-pass/Low-pass |
Detailed instructions for mounting the amplifier vertically using specific tools and brackets.
Instructions for connecting power, ground, and signal wires to the amplifier.
Explains the two automatic turn-on modes: +12V and DC Offset.
Describes how to set the input sensitivity for Hi or Low-level signals from the source unit.
Guides on adjusting the input gain to match source unit output with amplifier input.
Explains the variable bass boost control for increasing low-frequency output.
Describes how to adjust the variable crossover frequencies for optimal sound.
Instructions for installing and connecting the optional remote bass control.
Checks for power, remote turn-on, and ground connections when the power LED is off.
Troubleshooting steps for no output when the power LED is on, checking RCA and speaker connections.
Addresses issues indicated by a flickering red LED, usually related to low battery voltage.
Diagnoses problems indicated by a solid red LED, such as thermal or voltage protection.
Steps to resolve issues with no or low audio output from the amplifier.
Guides on troubleshooting engine noise interference in the audio signal.
Explains how to fix reduced bass response by checking speaker phasing.
Instructions for obtaining warranty service or returning defective merchandise to KICKER.
Lists conditions and situations that are excluded from the product warranty.
